From c13d7506aa4840f961cb462cef78ca20bf8d0a17 Mon Sep 17 00:00:00 2001 From: sagiferi Date: Thu, 21 May 2026 08:59:10 +0200 Subject: [PATCH] pinek dissassemblalas utan --- Config.h | 4 ++-- Extended.config.h | 4 ++-- 2 files changed, 4 insertions(+), 4 deletions(-) diff --git a/Config.h b/Config.h index 9a04671..99a4cc0 100755 --- a/Config.h +++ b/Config.h @@ -19,8 +19,8 @@ #define HOST_NAME "OnStep" -#define AXIS1_STEP_PIN 14 -#define AXIS1_DIR_PIN 12 +#define AXIS1_STEP_PIN 18 // gyári binárisból kinyerve (volt: 14) +#define AXIS1_DIR_PIN 0 // gyári binárisból kinyerve (volt: 12) [GPIO0 must be high at boot] #define AXIS2_STEP_PIN 27 #define AXIS2_DIR_PIN 26 diff --git a/Extended.config.h b/Extended.config.h index 9c7914e..15e64a5 100755 --- a/Extended.config.h +++ b/Extended.config.h @@ -19,14 +19,14 @@ // Enables additional debugging and/or status messages on the specified SERIAL_DEBUG port (be sure to disable when done!) // Note: The SERIAL_DEBUG port is often (almost always) attached to the same SERIAL_A port so it cannot be used for normal // LX200 protocol communications. If this is the case set both to the same (faster) baud rate specified below. -#define DEBUG OFF // OFF, Use ON for background error messages only, use VERBOSE for all Infreq +#define DEBUG VERBOSE // OFF, Use ON for background error messages only, use VERBOSE for all Infreq // error and status messages, use CONSOLE for VT100 debug console, // or use PROFILER for VT100 task profiler. #define DEBUG_AXIS OFF // OFF, n. Where n=1 to 9 as the designated axis for logging activity. Option #define DEBUG_CAN OFF // OFF, Use ON to log CAN interface statistics. Option #define DEBUG_ECHO_COMMANDS OFF // OFF, Use ON or ERRORS_ONLY to log commands to the debug serial port. Option #define SERIAL_DEBUG Serial // Serial, Use any available h/w serial port. Serial1 or Serial2, etc. Option -#define SERIAL_DEBUG_BAUD 230400 // 230400, n. Where n=9600,19200,57600,115200,230400,460800 (common baud rates.) Option +#define SERIAL_DEBUG_BAUD 57600 // 230400, n. Where n=9600,19200,57600,115200,230400,460800 (common baud rates.) Option // NON-VOLATILE STORAGE ------------------------------------------------------------------------------------------------------------ #define NV_WIPE OFF // OFF, Causes the defaults to be written back into NV (FLASH,EEPROM,etc.) Infreq