// Platform setup ------------------------------------------------------------------------------------ #pragma once // 1/100 second resolution #define HAL_FRACTIONAL_SEC 100.0F // This platform has 8 bit PWM #ifndef HAL_VCC #define HAL_VCC 3.3F #endif #ifndef ANALOG_READ_RANGE #define ANALOG_READ_RANGE 1023 // always use 2^n - 1, within the platform's limits #else #error "Configuration (Config.h): ANALOG_READ_RANGE can't be changed on this platform" #endif #ifndef ANALOG_WRITE_RANGE #define ANALOG_WRITE_RANGE 255 // always use 2^n - 1, within the platform's limits #else #error "Configuration (Config.h): ANALOG_WRITE_RANGE can't be changed on this platform" #endif // Lower limit (fastest) step rate in us for this platform (in SQW mode) and width of step pulse #define HAL_MAXRATE_LOWER_LIMIT 76.8 #define HAL_PULSE_WIDTH 10000 // in ns, estimated // New symbol for the default I2C port ------------------------------------------------------------- #include #ifndef HAL_WIRE #define HAL_WIRE Wire #endif #ifndef HAL_WIRE_CLOCK #define HAL_WIRE_CLOCK 100000 #endif // Non-volatile storage ---------------------------------------------------------------------------- #if NV_DRIVER == NV_DEFAULT #undef NV_DRIVER #define NV_DRIVER NV_AT24C32 #endif //-------------------------------------------------------------------------------------------------- // Internal MCU temperature (in degrees C) #define HAL_TEMP() ( NAN ) //-------------------------------------------------------------------------------------------------- // General purpose initialize for HAL // MCU reset #define HAL_RESET() (*((volatile uint32_t*)(PPB_BASE + 0x0ED0C))) = 0x5FA0004; //--------------------------------------------------------------------------------------------------- // Misc. includes to support this processor's operation